Mitsubishi Electric PAC-YT32PTA Manuel D'utilisation page 10

8. Setting Centigrade (
1
1 Press the [SET/MONITOR] button and select the "SET" mode.
2 Press the [DAY] and [DAILY TIMER] buttons simultaneously and select the "C/F" mode.
- Release the "C/F" mode by operating a button other than the [SET BACK] button.
- If no operation is performed within 3 minutes in the "C/F" mode, the set mode is released.
3 During the "C/F" mode, [SET BACK] blinks.
At this time, the SET BACK display changes SET BACK C ↔ SET BACK F each time the [SET BACK]
button is pressed. Set to match the connected remote controller.
- If a Centigrade type remote controller is connected, set to "SET BACK C".
- If a Fahrenheit type remote controller is used, set to "SET BACK F".
4 At the end of setting, press a button other than the [SET BACK] button and switch from the "C/F" setting
mode to the "SET" mode.
5 Press the SET/MONITOR button and return to the "MONITOR" mode.
10
°
C)/Fahrenheit (
I I I I
S M T W
SET
L L L L
M O NIT O R
SET/MONITOR
MODE A/B/OFF
WEEKLY SETTING
CLOCK
PAC-YT32PTA
5
°
F) at Set Back Operation
MODE A MODE B
I I I
T F S
L L L
0 3 6 9
12 15 18 21
SET BACK
DAY SET BACK DAILY TIMER MODE A/B
ON/OFF/SET BACK
L
TODAY
DAILY SETTING
2 34
12
24