General Information - CDVI Centrale Mifare DGM1D Manuel D'installation

INSTALLATION MANUAL
DGM1D
1-Door Mifare
®
Thank you for buying our products and for the confi dence you placed
in our company.

1] GENERAL INFORMATION

Compatible with Mifare
badges.
Up to 100 doors on the same site:
100 DGM1D with addresses from 1 to 100
+ gate address.
Hierarchization of access linked
to the badges during their creation:
1 access on the 100 doors possible + gate.
Reader: Very highly fl ame-resistant.
Programming Capability:
- Programming of the badges on PC,
- Transfer to the PCV123D,
- Downloading site with a simple
contact of the PCV123D
on the reader.
Number of residents on site unlimited
(black list) or limited to 200 badges
using (white list).
Cost effective solution.
Possibility to delete badges
for reprogramming.
Wireless cancellation of resident
and pass badges.
Snap-off terminal blocks.
WEEE & RoHS
CE Certifi cation
2] NOTES & RECOMMENDATIONS
Wiring
- The control unit is powered by a 12 V AC or DC /
300 mA.
- The cable used to link the control unit to the
TDG1-D is a SYT1 armored of 8/10th 2 pairs up
to 2 m and coaxial 50 ohms (RG58 or RG174/U)
up to 10 m maximum.
- Distance between the controller and the reader
should not exceed 2 meters with AWG35 cable
and 10 meters with a coaxial cable.
cdvi.com
12
cdvigroup.com
controller/reader system
- ISO 14443A
®
IP52
-20°C to +70°C
Dimensions :
- DGM1D (L x l x P) = 78 x 57 x 24 mm,
- Reader (Ø x P) = Ø44 x 41 mm.
1 door controller: 1 relay NO/NC.
Unlimited number of users.
Capacity: 200 badges (black list or white list).
Site code programmed on the card.
"Black list" mode:
- Stolen or lost badges are programmed
in the controller to deny access.
- The valid badges are not programmed
in the controller.
"White list" mode (allow to work with only
programmed badges).
Recommended cables: 2 pair of shielded AWG35
of the TDG1D up to 2 m. For a longer distance
up to 10 m, a coaxial cable of 50 Ohms.
1 request to exit input.
Compatible badges: PVP (MIFARE
the BV cards (ISO MIFARE
format) and ERV.
Connection to the reader with the PCV123
handheld terminal.
RS-232 Connection.
Input voltage: 12 V AC/DC.
Consumption: 300 mA max.
Cable
recommended cable between the controller
and the reader:
- 2 pairs shielded AWG35 of 2 meters. For a longer
distance up to 10 m, a coaxial cable of 50 Ohms
(RG58 or RG174/U) is recommended.
- In case the reader is close to an intercom system
or a sensitive device, it is recommended to
use a coaxial cabling (less or more than 2 meters).
EN
),
®
- credit card
®
Recommended
power supplies
ARD12 BS60