ShelterLogic 62780 Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. InsTAllInG coVeR WITH coVeR RAIls
A. Lay the cover on the ground next to the frame with inside of the cover (the side with the pipe pockets) facing
down and the webbing on the front and rear of the corner of the building. Pull cover over the frame.
B. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
C. Disassemble cover rails and slide through fabric pockets at each leg and reattach with clamps to each leg.
Repeat this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
D. Check and tighten Ratchets and Cross Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
INCORRECT
End Rib Cover Rail Clamps
800958
13202
10115
01011
01010
®
logo should
CORRECT
Webbing and Ratchets Securing Cover
802695
Page 10
802695
COvER RAILS
Middle Rib Cover Rail Clamps
800923
802695
01010
01011
01010
05_62780_62783_0B
13201
10115
802695
01011

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

62783

Table des Matières