Hoover HDI 3DO623D Mode D'emploi page 21

NEXT TIME – Regular usage
Every time you want to manage the
machine through the App, first you have
to enable the One Touch mode by
switching the appliance on, then selecting
the programme "P0".
Make sure you have unlocked your
phone (from stand-by mode) and you
have activated the NFC function; then,
follow the steps mentioned earlier.
If you want to start a washing cycle, load
the dishes and the detergent.
Select the desired function in the App
(e.g.: starting
"Clever Check-up"
statistics, etc...).
Follow the instructions on the phone
display, KEEPING IT ON the OneTouch
logo on the machine dashboard, when
requested to do so by the App.
Close the door of the appliance.
NOTES:
Place your smartphone so that the
NFC antenna on its back matches
the position of the One Touch logo
on the appliance (as illustred below).
a programme,
cycle, update
If you do not know the position of
your NFC antenna, slightly move the
smartphone in a circular motion
over the One Touch logo until the
App confirms the connection. In
order for the data transfer to be
successful, it is essential TO KEEP
THE
DASHBOARD DURING THESE THE
FEW SECONDS OF THE PROCEDURE;
a message on the device will inform
about the correct outcome of the
operation and advise you when it is
possible to move the smartphone
away.
the
Thick cases or metallic stickers on
your smartphone could affect or
prevent the transmission of data
between machine and telephone. If
necessary, remove them.
The replacement of some components
of the smartphone (e.g. back cover,
battery, etc...) with non-original
ones, could result in the NFC
antenna removal, preventing the full
use of the App.
The management and the control of
the machine via App is only possible
"by proximity": it is therefore
not possible to perform remote
operations (e.g.: from another room;
outside of the house).
21
SMARTPHONE ON THE