Optional Setup - Elipson Chroma 200 Mode D'emploi

Elipson's turntable also allows you to play old 78 rpm discs :
• Turn on the turntable at 45 rpm.
• Briefly put the speed switch on "0" and go back immediately on "45".
• The turntable will gradually stabilize at 78 rpm.
• Repeat the procedure to go back at 45 rpm.
VII. OPTIONAL SETUP
YOUR ELIPSON TURNTABLE WAS SET IN FACTORY TO ENSURE OPTIMUM UTILISATION.
THESE ADJUSTMENTS ARE FOR ADVISED USERS ONLY.
1. ANTI-SKATING
When the turntable is operating, the friction of
the diamond in the vinyl furrow creates a force
that pulls the tonearm towards the center of the
turntable. The anti-skating compensates this
attraction to reduce the distorsion it generates.
Ideally, the set up of the anti-skating is done
on a blank disc (not provided). The force of
the anti-skating can be manually adjusted
by the trackwheel on the tonearm. When the
cartridge is placed on the disc, it should not
move, either inwards or outwards the disc.
• Switch on the turntable.
• Place the cartridge in the middle of the blank disc.
- If the cartridge moves inside the vinyl, the anti-skating is too low :
you must increase the force by turning the trackwheel counterclockwise.
- If the cartridge moves outside the vinyl, the anti-skating is too strong :
you must decrease the force by turning the trackwheel clockwise.
2. ORIENTATION OF THE CARTRIDGE
In case of change of the cartridge, or if the
turntable has been moved, it may be necessary
to adjust the orientation of the cartridge. The
cartridge holder includes two screws to adjust
the angle of the cartridge according to the
type of vinyl (33 rpm or 45 rpm).
Check out our video tutorial on Youtube :
https://youtu.be/VPw_4e9diZA
Or scan the code with a smartphone to go
directly to the video.
33