Basic Connections - Kenwood CMOS-740HD Manuel D'utilisation

Connections
CAUTION
• If the engine key of your vehicle does not have the ACC position, branch the wire energized when the engine
key is ON and connect it to the accessory power cord.
• Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-)
terminal of the battery to prevent the short-circuiting incident.
• Do not bend the camera cord to a diameter of 40 mm or a radius of 20 mm or less.

Basic Connections

Navigation system/Video monitor compatible
with the HD camera picture quality
(commercially available)
Camera
Connect the camera to the camera connection cord.
Camera's cord length: 3.0 m (9.84 feet),
Power cord: 6.0 m (19.69 feet)*
* Including the power unit
Engine key
Main fuse
Battery
8 |
English
Connect to the rearview camera video input or to
the external video input of the video monitor.
Accessory power
(ACC)
Fuse
GND cord (Black)
Connect to a metallic part of vehicle (a part of chassis
connected to the negative side of power supply).
GND
Video cord
Accessory cord (Red)
Connect to the ON-OFF switchable power supply.
Do not connect to a permanently ON power supply.
Power cord
Power unit
Fuse (2A)