Table des Matières
Publicité
7.
Operation
1. Put the switch in the "ON"-position.
2. Put the KSR6 on the ground; it should start moving forward.
3. When it detects an obstacle, it will turn to the left. As long as there is no obstacle, it will continue to move
forward.
4. Adjust the variable resistor and thus the detection distance (to the left = higher sensitivity, to the right =
lower).
8.
Troubleshooting
1. Make sure all components on the PCB are in the right position. Pay particular attention to the polarity of the
IR diode and the photo transistor.
2. Make sure the wiring is connected correctly.
3. The sensitivity may be affected by fading battery power. Adjust the variable resistor to improve the range.
4. Apply a little bit of machine oil to the axles of the gears if the KSR6 isn't running smoothly.
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 03 – 28/08/2019
KSR6
10
©Velleman nv
Publicité
Table des Matières
