Electrical Safety - Work Men WMPRE130-234BM Traduction Des Instructions D'origine

Use the power tool, accessories and cutting tools,
etc., in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work which needs to be done. Using a power
tool in ways for which it was not intended can lead
to potentially hazardous situations.
Service
Your power tool should be serviced by a qualified
specialist using only standard spare parts. This will
ensure that it meets the required safety standards.
as well as the additional safety instructions.
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger of
In this manual and/or on the machine the following
symbols are used:
Denotes risk of personal injury
or damage to the tool.
Read manual before use
Always wear hearing
Always wear safety goggles
Always wear a dust mask.
In accordance with essential
applicable safety standards of
European directives
suffocation!
protection
Double insulated
ADDITIONAL SAFETY INSTRUCTIONS FOR
COMPACT HOBBY TOOLS
Do not use the tool on light
metal with a magnesium
content exceeding 80%, as
§ Make sure that the accessories used are
suitable for the maximum speed stated in the
technical data.
§ Make sure that the accessories are mounted
according to the instructions.
§ Only use accessories and adapters supplied by
the manufacturer.
§ Make sure that sparks cannot hit any persons or
set flammable materials alight.
§ Always wear safety goggles, hearing protection
and if necessary other protective means, such as
working gloves, hard hat, etc.

ELECTRICAL SAFETY

Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
Your multi tool has been designed for drilling,
routing, engraving, polishing, cutting, grinding
and sanding of wood, metal, plastics and stone. It is
not designed for commercial use.
1 On/off switch
2 Speed adjusting wheel
3 Carbon brush holder
4 Spindle lock button
5 Collar
6 Collet nut
Mounting an accessory
_ Keep the spindle lock button (4) depressed.
_ Use the spanner (7) to slacken the collet nut (6).
_ Insert the shaft of the accessory into the collet.
_ Use the spanner to tighten the collet nut.
_ Release the spindle lock button.
_ In order to remove the accessory, proceed in
reverse order.
Before mounting an accessory,
always unplug the tool.
Replacing the collet
_ Keep the spindle lock button (4) depressed.
_ Use the spanner (7) to slacken the collet nut (6).
_ Remove the collet nut and the old collet (8).
_ Place the new collet.
_ Replace the collet nut.
_ Release the spindle lock button.
this type of metal is
flammable.
15