Stihl FG 3 Notice D'emploi page 19

7
Turn the adjusting screw (7) (anti-
N
clockwise – file lower, clockwise –
file higher) until approx. 1/4 of the
diameter of the sharpening file
protrudes above the tooth head
FG 3
9
By turning theknurled nut (8), adjust
N
the stop (9) until it lies against the
back of the cutter that is to be
sharpened (master cutter)
8
4
10
Then turn theknurled nut a little
N
further until the tooth face presses
against the file and the stop
tube (10) lifts up from the stop
roller (4) by approx. 0.1 to 0.2 mm
English
4
10
17