Lindy 43206 Manuel Utilisateur page 4

English
Tool operation
To open the tool, squeeze the handles together and release.
To lock the handles closed - for storage - squeeze the handles together to final 6
To Strip & Terminate Cable
Insert selected 4P, 6P or 8P UTP/STP cable between the stripping blades as follows.
a. Insert 4P or 6P cables from the top end of the stripper block
until they are level with the stop guide - stripping length 6mm.
Stop guide
b. Insert 8P cables from the top end of the stripper block
between the stripping blades and let them extend a little past
the lower cutting blade -stripping length 12mm.
Lower
c. Insert UTP/STP cables from the lower side of the tool - into
cutting blade
the UTP/STP recess. Close the handles and turn the tool
counter-clockwise in a full circle. Keep the cable perpendicular
to the tool when pulling it from the tool - stripping length
as required.
Insert the stripped cable into the required modular plug
Insert UTP/STP
ensuring the wires are the same length and placed under the
into UTP/STP recess
gold contacts. The wires should be between the tab and the
gold contacts.
Place
down/crimping section of the Tool, and then squeeze the
handles until they stop.
Release the handles and remove the crimped plug from the
tool.
To crimp DEC/offset plugs, follow the above steps inserting the
DEC/offset plug & cable into the 6P punch down.
Note - To prevent incorrect crimping during this process, turn
the ratchet release on the reverse of the tool counter
clockwise.
the modular plug
3
User Manual
th
ratchet and release.
with cable into the punch