Initial Use; Unpacking The Air Dehumidifier; Setting Up The Air Dehumidifier; Operation - Beurer LE 40 Mode D'emploi

Control unit with LCD display
4
3
13
1. POWER button (switches the device on/off)
2. MODE button (mode selection)
3. SETTING button (air humidity setting)
4. TIMER button (automatic switch-off)
5. Fan speed ( = high,
6. Defrost function active
7. Current ambient temperature

5. Initial use

5.1 Unpacking the air dehumidifier

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all plastic films.
4. Check the device, mains plug and cable for damage.

5.2 Setting up the air dehumidifier

1. Place the air dehumidifier on a firm, level and water-resistant surface to prevent vibrations and noise.
2. Set up the air dehumidifier in such a way that provides 30 cm clearance on all sides.
3. Ensure that the ventilator air supply and ventilator air delivery are never blocked.
4. Insert the mains plug into the socket. Ensure the cables do not pose a trip hazard.
5. Before using the device for the first time, it should be left in an upright position for at least 6
hours (however ideally 24 hours).

6. Operation

6.1 Switching the air dehumidifier on/off

1. Insert the mains plug into a suitable socket. The air dehumidifier sounds two acoustic signals.
2. To switch on the air dehumidifier, press the POWER button. The device now continuously dehumidifies
at the highest level.
3. To switch off the air dehumidifier, press the POWER button again. The air dehumidifier stops the dehu-
midification.
5 6
12 10
11
= low)
7
9
8
8. Current ambient air humidity
9. Timer function activated (remaining time)
10. Target air humidity level
11. Full water tank
12. Dehumidifying active
13. Continuous dehumidifying
(e.g. laundry drying function)
18
1
2