SOLAC MD7404 Mode D'emploi page 10

larly switched on and
off by the utility.
- WARNING: Do not
use this applian-
ce near bathtubs,
showers, basins or
other vessels contai-
ning water.
This symbol
means that product
must not be used
near water.
- If the connection to
the mains has been
damaged, it must
be replaced, take
the appliance to an
authorised technical
support service. Do
not attempt to disas-
semble or repair the
appliance by yourself
in order to avoid a
hazard.
- Ensure that the voltage indica-
ted on the rating label matches
the mains voltage before plug-
ging in the appliance.
- Connect the appliance to a soc-
ket that can supply a minimum
of 10 amperes.
- The appliance's plug must fit
into the mains socket properly.
Do not alter the plug. Do not
use plug adaptors.
- Do not force the power cord.
Never use the power cord
to lift up, carry or unplug the
appliance.
- Do not wrap the power cord
around the appliance.
- Do not clip or crease the power
cord.
- Do not allow the power cord to
hang or to come into contact
with the hot surfaces of the
appliance.
- Check the state of the power
cord. Damaged or tangled ca-
bles increase the risk of electric
shock..
- Do not touch the plug with wet
hands.
- Do not use the appliance if the
cable or plug is damaged.
- If any of the appliance casings
breaks, immediately disconnect
the appliance from the mains
to prevent the possibility of an
electric shock.
- Do not use the appliance if it
has fallen on the floor, if there
are visible signs of damage or if
it has a leak.
- CAUTION: Maintain the applian-
ce dry.