Krups PERFECT MIX 9000 Mode D'emploi page 5

1. Blender shaft: Fig. 2 to 4
1.1 Assembly
„ „
Insert the blender head (B2) or the crushed ice head (B3) (according to model) in the
Cap (B4) Fig. 2.
„ „
Screw the shaft (B1) onto the head making sure it is fitted properly and secure Fig. 3.
„ „
Screw the shaft (B) onto the motor unit (A) making sure it is fitted properly and secure,
then plug in the appliance. Fig. 3 and 4.
1.2 Use
„ „
Insert the shaft (B) in the beaker to mid-height Fig. 5, then select speed 1 using
button A2 and press the Start button (A3).
„ „
Remove the cap (B4).
„ „
Use the speed selector A2 to increase the speed progressively if necessary.
„ „
Your appliance is equipped with a Turbo function that allows you to use it in full
power mode by pressing button A4. Fig. 6.
„ „
In order to avoid splashes, insert the shaft (B) in your preparation before turning on
the appliance Fig. 7.
„ „
If you mix hot ingredients directly in a cooking container, withdraw the container from
the heat source before doing so Fig. 8.
„ „
The food must cover the lower part of the blender base to guarantee effective
functioning.
WARNING: Do not turn on the appliance when the head is not immersed
in food.
„ „
Moving the shaft up and down inside the beaker will not make the hand blender more
effective. Leave it at mid-height and towards the centre of the container.
„ „
In order to avoid splashes, stop pressing the Turbo speed button (A4) or Start/Stop
button (A3) before taking the hand blender shaft (B1) out of your preparation. Fig. 9.
Practical tips
For fruit-based preparations, remember to slice the fruits and remove any stones before
putting them in the mixing container.
Do not use the blender head (B2) for hard food products such as ice cubes, sugar,
coffee beans, grains, or chocolate.
If you wish to make crushed ice, use the crushed ice head (B3) (according to model).
1.3 Dismantling
„ „
Disconnect the appliance.
„ „
Unscrew the shaft and then the head using the cap (B4) Fig. 10.
2. Double whisk (D) (according to model): Fig. 11
2.1 Assembly
„ „
Attach the double whisks (D2) to the whisk adaptor (D1).
„ „
Place the whisk adaptor (D1) on the motor unit.
„ „
Screw on completely Fig. 11.
2.2 Use
„ „
Insert the double whisks in a high sided container, select speed 1 with the A2 button
and turn on the appliance by pressing A3.
„ „
In order to avoid splashes, insert the shaft (B) in your preparation before turning on
the appliance Fig. 12.
„ „
As your preparation becomes thicker, use the speed selector button A2 to increase
the speed progressively.
2