Setup - Step 1 - Kanto AVS Série Manuel De L'utilisateur

Step 1: Preparation
Step 1.1 Remove Cable Covers
The AVS Series Wall Mount Shelving System comes
pre-packaged from the factory with the cable
covers snapped in place on the wall plates' (I) cable
management clips . Remove the Cable Covers (L)
and End Caps (M) by sliding them off of the cable
management clips (as shown in Diagram A), and set
them aside .
NOTE- The AVS3 is shipped with the cover snapped in
place on one of the three wall plates.
Step 1.2 Connecting Wall Plates
With the AVS2 and AVS3, you can connect wall plates
together by inserting the tab of one wall plate into the
slot on the other wall plate (as shown in Diagram B) .
If you are connecting wall plates, mount the top wall
plate first, then insert the tab of the next wall plate from
the bottom and continue .
Step 1.3 Choose Layout
The AVS2 and AVS3 can be installed as a single
intreconnected shelving unit, or as two separate
shelving units . Consider how you want to interconnect
the wall plates to provide the ideal shelf configuration
for your installation .
All possible AVS wall plate configuration options are
shown in Diagram C .
Rear
View
Diagram B
M
AVS1 AVS2 AVS2
separate linked
Diagram C
L
I
Diagram A
AVS3 AVS3
separate single +
double
English
AVS3
triple
5