Setup - Steps 3, 4; Introducción - Kanto AVS Série Manuel De L'utilisateur

Step 3: Attach Shelf Supports
With the wall plate(s) secured to the wall, you can now attach
the shelf support(s) (J) at the desired height, using two M6
x 10mm bolts (F), as shown in Diagram G . Tighten using the
Allen Key (I) .
If necessary, you can move the location of the cable
management clips by unscrewing the M6 x 10 mm bolt
holding the clip to the wall plate, repositioning the cable
management clip, and screwing the M6 x 10mm bolts . Tighten
using the Allen Key (I) . The shelf system does not interfere
with the cable covers, so you can position the shelf supports
and cable management clips wherever you wish .
x2
Step 4: Attach Shelves
With the shelf support(s) attached at the desired height,
you can now attach the glass shelf (or shelves) (K) . Use two
M6 x 15mm bolts (G) and two plastic washers (H) for each
shelf, as shown in Diagram H .
3.2
Diagram G
Diagram H
3.1
J
F
English
Cable
Management
Clip
G
K
H
7