Manual Setting; Cleaning Mode - Sanit INEO SCOP Mode D'emploi

ENGLISH
EN

Manual setting

Settings

(cleaning mode)

I
Stop function
II
Light mode
Automatic
III
flushing
IV Colour
V
Default setting
VI Detection range
5
sec.
Description
Stops the flushing function so that the flush panel and toilet
bowl can be cleaned. The flushing function can be activated
again after cleaning has been finished. The flush panel is auto-
matically activated after 3 minutes.
Three settings:
Welcome - lighting is switched on when someone approaches
and switches off when they move away
ON - lighting is switched on permanently
OFF - l ighting is switched off permanently and only lights up
when flushing is triggered.
Automatic flushing can be switched ON and OFF. When the
function is switched on, the flush panel triggers a full flush auto-
matically when the user goes out of the toilet. The user does
not have to do anything.
Setting of the light colour, there is a choice of:
cold white, azure, magenta, green-yellow, blue, green, red
Resets functions II, III and IV to the default setting
Automatic range regulation
3 minutes
I Cleaning mode
Cover both flush buttons at the same time by holding your
hands about 4 cm in front of them. The flush panel will
start to flash RED after a few seconds, you can now move
your hands away again.
Cleaning mode is now activated for 3 minutes.
Cleaning mode deactivates automatically after 3 minutes
and the flush panel is ready for operation again. The func-
tion of the flush panel can also be reactivated by covering
both flush buttons again.
17
Default setting
3 minutes
Welcome
On
Blue