Comfort Mode; Antifreeze Mode; Program Mode - Warm Tech RIF600-4 Traduction Des Instructions D'origine

To switch on or off your heater, press briefly the ON / OFF button. After pressing
heater turns into COMFORT mode.
To change the MODE, press the ENTER button. Each time you change the MODE as follows:
COMFORT- ECO-ANTIFREEZE – PILOT WIRE.
2 / LED display
- TIME / TEMPERATURE

COMFORT MODE

ECONOMIC MODE

ANTIFREEZE MODE

PROGRAM MODE

KEYBORD LOCK
COMFORT MODE
This is the normal mode of your heater. The temperature will be maintained as you set. The pre-set
temperature is 22 º C. Set COMFORT MODE for your heater when rooms are occupied.
ECONOMIC MODE
The appliance starts to work when the room temperature is about 3.5 ° C below the temperature that
you set. The pre-set temperature is 18.5 ° C. Use ECO MODE when rooms are unoccupied.
If you want to increase or decrease the temperature of the ECONOMIC and COMFORT MODE, press
the UP / DOWN buttons to reach the desired temperature, stepping 0.5 ºC. The temperature can be
adjusted from 7 °C to 35 ºC.
ANTIFREEZE MODE
The appliance starts to work when the room temperature is around 7 ° C. Use this position when
rooms are unoccupied for long periods of time (e.g. holidays).
PROGRAM MODE
At the first use of your heater (or after a power failure), you must set the time and day of the week:
1. Press the button
2. First set the hours by pressing the buttons UP and DOWN, press OK.
3. Then set the minutes by pressing the buttons UP and DOWN, press OK.
4. Then select the day of the week 1 = Monday, 2 = Tuesday, 3 = Wednesday, 4 = Thursday, 5 =
Friday, 6 = Saturday, 7 = Sunday, press OK.
The next step is time setting of your heater for each day (from 00 :00 to 24 :00)of the week (Mon to
Sun). For every hour, you must choose either COMFORT mode or ECONOMIC mode.
Press UP to make your heater work on the COMFORT mode during this time or press DOWN to run
on the ECO mode. COMFORT is represented by a solid bar , ECO by empty bar
Once you have made your selection for the day, you can:
a. press OK to enter into the next day.
b. press OK for 3 seconds to enter into next day by copying the program of the day you just chose.
for 3 seconds until the time flashes.
button, your
.