Troubleshooting - MAXXMEE Dekokamin Mode D'emploi

Decorative Fireplace
6. Release the plug connection and
connect a new ultrasonic atomiser to
the plug connector of the main unit
(Picture E).
 
If the cable drops into the hous-
ing, remove the water tank and
thread the cable back through the
corresponding opening.
7. Stow the plug connection in the hous-
ing and fi x the cable in place by fi rmly
pressing the plug in the housing.
8. Insert the ultrasonic atomiser into the
mount in the water tank and its cable
into the cable guide. When you do
this, make sure that the ultrasonic
atomiser is fully inserted and is fi tted
straight.
9. Insert the splash guard into the water
tank and place the cover on the main
unit.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an
electrical device yourself!
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit of the mains plug.
The plug socket is defective.
► Try another plug socket.
The toggle switch (6) is in the O position.
► Move the toggle switch into the I
position.
The water tank (7) is empty. In this case,
the device cannot be switched on.
► Fill the water tank.
08827_Inlay_DE-EN-FR-NL_A5_V1.indb 15 08827_Inlay_DE-EN-FR-NL_A5_V1.indb 15
An ultrasonic atomiser (1) does not
work.
The diaphragm is dirty.
► Clean the diaphragm.
The ultrasonic atomiser (1) is not plugged
correctly on the connector of the main
unit (5).
► Check the plug connection and
correct it if necessary.
The fl ames are small. / The fl ame
pattern does not develop.
The device has only just been switched on.
► The device requires a little time to
produce a realistic flame pattern. The
flame pattern will develop as the de-
vice is used and become increasingly
more vivid.
The diaphragm of the ultrasonic atomis-
ers (1) is dirty.
► Clean the diaphragms.
The ultrasonic atomiser (1) is tilted in the
mount.
► Correct the fit of the ultrasonic atom-
iser. The diaphragm must be pointing
straight up and must not be tilted.
The cable of the ultrasonic atomiser (1) is
protruding over the diaphragm.
► Correct the fit of the cable. The
area above the diaphragm needs to
remain clear.
EN
15
25.08.2020 17:13:31 25.08.2020 17:13:31