Use; Cleaning And Storage - MAXXMEE Dekokamin Mode D'emploi

Decorative Fireplace
4. Carefully fi ll the water tank with water
using a measuring cup or something
similar.
5. Place the splash guard on the water
tank and the cover on the main unit.

USE

Please Note!
■
The device must have clearance of at
least 1 m above it and to all sides and
be placed on a dry, even, solid and
moisture-resistant surface. Do not po-
sition the device near to moisture-sen-
sitive objects and materials. Harmful
microorganisms may be produced on
damp materials, such as curtains or
such like.
■
The water in the water tank needs
to be changed every two days and
the water tank needs to be cleaned
thoroughly in order to prevent the
formation of harmful microorganisms.
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Only use the device when all halogen
lamps are inserted.
■
Do not operate the device unsuper-
vised so that you can intervene imme-
diately if there are any faults.
1. Fill the water tank (7) (see the "Filling
the Water Tank" chapter).
2. Fully unwind the connecting cable
and connect it to a plug socket.
3. Move the toggle switch (6) into the I
position.
4. Press the On / Off button (4) to switch
on the device. The halogen lamps (11)
start to light up. After around a min-
08827_Inlay_DE-EN-FR-NL_A5_V1.indb 13 08827_Inlay_DE-EN-FR-NL_A5_V1.indb 13
ute the ultrasonic atomisers (1) start
to produce a water mist. The device
requires a little time to produce a real-
istic fl ame pattern. The fl ame pattern
will develop as the device is used and
become increasingly more vivid.
 
To accelerate the fl ame develop-
ment, warm water (approx. 40 °C
to 60 °C) can be used.
Please Note: If there is not enough
water in the water tank, the device
switches off automatically.
5. If the device is no longer going to
be used, press the On / Off button
to switch it off. The halogen lamps
go out and the ultrasonic atomisers
switch off.
6. Move the toggle switch to the O posi-
tion and pull the connecting cable out
of the plug socket.
 
After use, there may still be water
remaining on the splash guard
and on the cover.

CLEANING AND STORAGE

Please Note!
■
The water tank needs to be emptied
and cleaned every two days.
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. They may damage
the surfaces.
• Make sure that the device is not con-
nected to the mains power.
• Wipe down the device with a soft,
damp cloth. Remove more stubborn
dirt with a little detergent.
• If necessary, clean the diaphragms
of the ultrasonic atomisers (1) with a
cotton bud soaked in alcohol.
EN
13
25.08.2020 17:13:30 25.08.2020 17:13:30