Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CPA395
ASSEMBLY AND INSTALLATION
IMPORTANT ! :
The CPA395 is designed to be mounted to
double 2" x 4" wood stud cross bracing (6" on center) between
two ceiling joists with a maximum drywall covering of 5/8".
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's responsibility
to make certain the structure to which the mount is being
attached is capable of supporting five times the weight of the
CPA mount and all attached equipment. Reinforce the
structure as required before installing the mount.
NOTE:
The following instructions assume a suitable mounting
structure and surface exists prior to installation.
1.
Using CPA395 plate (A) as a template, mark locations of
two pilot holes (See Figure 1). Ensure the marks are in the
center of wood joists.
1
Figure 1
2.
Drill 1/4" diameter pilot holes into wood joists (See Figure 1).
Ensure pilot holes are straight.
3.
Install and tighten two 3/8" x 2-1/2" (minimum) Grade 2 lag
screws (not included) through CPA395 (A), into wood joist
(See Figure 2).
4
x 2
wood studs
(A)
3
Figure 2
Installing Extension Column
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components located within the mounting system of the
CPA395 does not exceed 500 lbs (226.8 kg).
1.
Route cables through extension column (not included).
2.
Install UL Listed CPA Extension Column Series (not
included) into CPA395.
NOTE:
Installation of hex head self-tapping screws will be
easier when screws are carefully aligned with holes in
extension column, and a drill and nut driver is used. If
a drill will NOT be used, a small amount of pressure will
be needed to get the self-tapping screws started.
Installation Instructions
x 2
Publicité
Table des Matières
