Luvion Exact Guide De L'utilisateur page 5

1. The measured value is lower than
0°C/32.0°F under milk
temperature mode.
2. The measured value is lower than
32°C/89.6°F under body
temperature mode.
Retrieval of stored readings, Storing 20 readings
LCD display Operation instructions and explana-
tion of displays
Press and hold down button (3) for
4-8 seconds and LCD displays "---"
with the M symbol blinking.
Press button (3) again and the LCD
displays the first stored reading with
the M symbol blinking.
Press button (3) and the LCD will
display the serial number of the
stored reading for 1 second and
then display the measured tempera-
ture. There are 20 stored readings.
The LCD display will only display
"---", °C/°F and the M symbol with
the M symbol blinking if there are
no stored readings available.
8
C/F conversion
3 short beeps and red
backlit for 3 seconds.
Sound and backlit
Error message
If the thermometer is not used for 10 seconds it will automatically switch off.
LCD display Operation instructions and explana-
tion of displays
Press and hold down button (3) for
8-12 seconds under shutdown state
to enter the C/F conversion mode.
Press button (3) within 5 seconds af-
ter release to change the temperature
unit from °C to °F or from °F to °C
LCD display Operation instructions and explana-
tion of displays
The LCD Display will display "Er1"
when the ambient temperature ex-
ceeds 40.0 °C / 104°F or drops below
10.0 °C / 50.0°F
The LCD Display will display "ErC" if
there is EEPROM data reading error
or if the correcting process is not
finished. Please contact your supplier.
The LCD Display will display the low-
voltage signal (non blinking) when
the battery voltage is below 2.61V .
Please replace the battery.
Sound and backlit
Sound and backlit
3 short beeps and
red backlit for 3
seconds.
3 short beeps and
red backlit for 3
seconds.
9