Operation; Applications; Installing/Removing Battery Pack - Ryobi P760 Manuel D'utilisation

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove the battery pack from the product and
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing bat-
tery pack or unplugging extension cord will prevent acci-
dental starting that could cause serious personal injury.
NOTICE:
Always refer to the manual for any device recommended
for use as an attachment or accessory. Proper use of
any device, when attached to the product, is the sole
responsibility of the operator. Improper use may damage
the device or the product.
WARNING:
This product is capable of producing sound levels that
can be dangerous to long-term hearing. Listening to
music at high volume for any period of time can cause
noise-induced hearing loss. The higher the volume, the
less time required before your hearing could be affected.

APPLICATIONS

You may use this product for the following purposes:
 Connecting to MP3 players or other audio devices
 Listening to FM radio
 Connecting with other SKAA

INSTALLING/REMOVING BATTERY PACK

See Figure 1, page 13.
NOTE: Always remove the AC power adaptor when installing
the battery pack.
To install battery pack:
 Place the battery pack in the product, aligning the rib on
the battery pack with the groove in the battery port.
 Make sure the latches on the battery pack snap into place
and the battery pack is secured to the product before
beginning operation.

OPERATION

devices
®
6 - English
To remove battery pack:
 Depress the latches on both sides to release the battery
pack.
. NOTE: Always remove battery pack when not in use.
Leaving the battery pack connected for long periods of
time may drain the battery pack.
INSTALLING/REMOVING AC ADAPTOR
See Figure 1, page 13.
NOTE: The AC adaptor and battery pack cannot be installed
onto the speaker or used at the same time.
 Turn the product off.
 Remove the battery pack.
 Insert the barrel plug of the power cord into the product
as shown.
 Connect the other end of the power cord to the AC outlet.
 Make sure the power cord is secured before beginning
operation, and the speaker is placed in a location that will
prevent tripping over the cord or pulling the cord loose
from the speaker or the outlet.
TURNING THE SPEAKER ON/OFF
See Figure 2, page 13.
 Press the GEAR/POWER button for a half second to turn
the product on.
 Press and hold the GEAR/POWER button for two sec-
onds to turn the product off.
NOTE: Pressing the GEAR/POWER button also rotates
through the modes.
Score PRIMARY SPEAKER (P760)
™
The Score Primary Speaker provides wireless connectivity
™
to most audio-capable mobile devices, MP3 players, etc.,
via Bluetooth
wireless technology. The Primary speaker
®
can also wirelessly connect up to four additional Score
speakers via SKAA technology. For more details, visit
®
www.skaa.com.
The following instructions are specific to the Score
Primary speaker. Instructions for the Secondary Speaker are
described later in this manual.
NOTE: P761 Secondary Speakers do not operate inde-
pendently of the Primary Speaker. You must first set up the
Primary speaker and then connect Secondary speakers.
The Primary Speaker may be used as a Secondary speaker,
but only when there is another Primary Speaker set up to
connect to the audio source.
For complete operating instructions for all external devices,
always refer to the manual that was included with the device
you wish to use.
™
™