Installing The Smartbox Mini; Troubleshooting - SelfClimat SmartBox mini Instructions De Montage Et D'utilisation

INSTALLING THE SMARTBOX MINI

Before installation, check that the product is complete and has not suffered any damage
during transport.
ASSEMBLY, START-UP and MAINTENANCE are to be carried out by a specialised
company in terms of water law.
For the system to function as intended it must be installed professionally in compliance with
the technical instructions applicable to the planning, construction and operation of the entire
system.
These regulations also include the accident prevention regulations of the employers' liability
insurance associations, the VDE regulations, and the installation and operating instructions.
Installation instructions
The display unit has a wall installation housing and is operated with the top of the housing
closed. Installation and start-up by a specialised installer is carried out with the display unit
open.
Installation of the digital display unit
1. Loosen the screw on the bottom of the digital display unit and remove the top of the
housing.
2. Place the digital display unit on a suitable position on a smooth, vertical wall and pierce
the pre-cut holes on the inside back wall of the housing. Mark the points for installation.
3. Place the digital display unit on the marks and fix it in place using the supplied anchors
and screws.
4. Close the top of the housing and tighten the screw on the bottom of the digital display unit.

TROUBLESHOOTING

Fault cause
Battery warning Battery _ _%
when remaining capacity is low
No display
Batteries empty
Error code
Error 0001
Error 0002
NOTICE
Do not damage electronic components.
Use a suitable tool to pierce the openings.
Action
Constant check
Meaning
No contact with FSA-E
Connection cable on the digital display unit not connected
Replace batteries
Check the connection between the magnetic sensor
and the magnetic encoder in the connection plug on
the FSA-E
Connect the cable
22/72
®
SmartBox MINI
Artikel-Nr. 308 051