Start-Up - SelfClimat SmartBox mini Instructions De Montage Et D'utilisation

START-UP

Operating elements and screen of the digital display unit
The device is adjusted once when it is put into operation. The digital display unit is put into
operation after the cable has been connected and the batteries have been inserted.
When it has been started, the digital display unit works in display mode. The readings are
shown in a 1-line LCD display with 16 characters. The display has background lighting so that
the readings can be seen in all lighting conditions.
View of the digital display circuit board
Terminal assignment from left to right:
1 2
ws = White bn = Brown
Setting a
parameter:
Quitting the
setup mode:
Programming 1st steps
3
gn = Green gb = Yellow
Press [Enter] to open setup mode.
Select the desired setting parameter via PLUS [+].
Press [Enter] to call up the value selection for the parameter.
Set the value with MINUS [-] / PLUS [+], press [Enter] to save.
You can quit the setup mode at any time.
Select "Exit" and press [Enter]
to go back to the standard display mode.
1. Touch the sensor bar to activate the display.
2. The 1st menu item "Unit" is displayed.
4 5
gr = Grey
18/72
SmartBox
Activate the display on the
sensor bar
The parameters are adjusted
with three small push-
buttons:
MINUS ENTER
SW6 SW4
These are located on the
circuit board above the
terminal block.
Artikel-Nr. 308 051
®
MINI
PLUS
SW5