SOLAC MD7420 Mode D'emploi page 12

task.
- This appliance is for household use only, not
professional, industrial use.
- Store this appliance out of reach of children
and/or persons with physical, sensory or redu-
ced mental or lack of experience and knowled-
ge.
- Do not store the appliance if it is still hot.
- Do not store or transport the appliance if it is
still hot.
- Never rest the appliance into a surface while in
use.
- Do not use the appliance with pets or animals.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
- SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- CAUTION: There is a risk of fire if the
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
A On/off switch
B Accessory locking and unlocking button
C Comb accessory
D 32mm curling tong accessory
E 19mm curling tong accessory
F Spiral sleeve
G Brush sleeve
H Plate support
H.1 H.2. Crimper/Straightener plates
I Hanging loopp
J Storage bag
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Prepare the device according to the function
you wish to perform.
ASSEMBLY THE ACCESSORIES
- Install all accessories with the appliance cold to
avoid burns.
PLACING AND REMOVING ACCESSORIES D,
E AND H
- 1. Press the lock and unlock button (B), insert
the desired accessory in the direction indicated
by the arrows. (Fig. 1)
- 2.To remove the accessory follow the reverse
procedure.
PLACING AND REMOVING COMB C
- 1.By pressing the button C, introduce the acces-
sory in the opposite side of the power button A.
(Fig. 2)
- 2.To remove the accessory follow the reverse
procedure.
PLACING AND REMOVING BRUSHES F AND G
- 1. Slide the brush through the curling tong E.
- 2.To remove the brushes, press the curlong
tong and turn the brush 90 degrees and slide it
out. (Fig. 3).
PLACING AND REMOVING PLATES H.1, H.2,
- 1. Slide the plate down, till to hear the click.
- 2.To remove the accessory press the accessory
side buttom and slide up. (Fig. 4)
USE:
- Attach the desired accessory.
- Unroll the cable completely before plugging on
in.
- Plug the appliance into the mains.
- Start the device by pressing the on / off switch.
CURLING TONGS D AND E
- 1.Prepare a small section of hair.
- 2. Press the lever to open the tong, then slip the
tips of the hair between the roller and the tong.
- 3. Release the clamp to close it.
- 4.With the other hand hold the insulated plastic.
- 5. Rotate the appliance to curl up to the scalp,
take care not to burn yourself.
- 6. After 5 seconds, unroll carefully.
- 7. Repeat the process with the rest of the hair.
(Fig. 5)
BRUSHES F AND G
- 1.Prepare a small section of hair and wrap it
around the brush.
- 2.Keep for 5 to 10 seconds and unroll. (Fig. 6)