Important Notice - Beta 560/C6 Mode D'emploi

TORQUE MULTIPLIER, RATIO 6,5:1 (1500Nm) - 12:1 (2500Nm)
IMPORTANT NOTICE: The multiplication factor 6,5-12:1 means that the input torque is
multiplied 6,5-12 times out of the multiplier.
CAUTION: Torque multipliers must always be used with torque wrenches; no impact
wrenches may be used.
A

IMPORTANT NOTICE:

These tools are meant for professional use; therefore, they must be used by trained personnel only. Any
other use shall be deemed to be improper. Always use personal protection devices and comply with
safety standards in the workplace.
Set the torque wrench according to the required tightening
value; mount the reaction foot or lever on the multiplier, fixing
it with the screw and the required socket. Place the multiplier
on the hexagon, rotating it by hand until the reaction foot or
lever firmly stands on a wall/nut etc.
Fit the male square of the torque wrench into the female
square of the torque limiting socket (A), which will not allow
maximum input torque to be exceeded. The torque limi-
ting socket will break if maximum input torque is exce-
eded, thus preventing the multiplier from being dama-
ged. Then fit the torque limiting socket into the female
square of the multiplier and tighten as much as needed.
As the forces accumulated inside must be released, rotate the
multiplier in the opposite direction. This operation must be
carried out with great caution to prevent any damage to
things and/or people.
CAUTION: Do not exceed the MAX input value.
To tighten, use impact sockets only, according to the MAX
torque values applicable to the individual sockets.
While using any extension bars, it is recommended that the
multiplier should be perfectly aligned while tightening; exten-
sion bars exceeding 250 mm in length should not be used.
ART. 560/C6 Max out 1500Nm
ART. 560/C12 Max out 2500Nm
Max in 231Nm ½" -
Max in 208Nm ½" -
GB
¾"
1"