Replacing The Bulb - Hansa LED Maxlight Mode D'emploi

– Never pull the mains cord out of the sock-
et by the cord, instead always take hold of
the mains plug.
– Never use the connector cord as a carry-
ing strap.
– If the mains cord of this device is dam-
aged, it must be replaced by the man-
ufacturer or its customer service
department or a person with similar quali-
fications in order to avoid risks.
– Render the device, which has outlived its
purpose, unusable. Pull the mains cord
out of the socket and cut the mains cord
in half.
Danger to children and other
persons!
Children often do not recognise
the risks of handling electric ap-
pliances or underestimate them. Children
can become trapped in the packing film
when playing and suffocate.
– Do not allow children to play with the
packing film and never allow them to use
electric appliances without supervision.
Fire hazard!
Do not use any sprays or the like
to clean the light.
Risk of injury!
The light from the bulb is very
intense.
– Do not look directly into the light.
6
OPERATING INSTRUCTIONS
GB
LED floor lamp LED Maxlight
Notes on the place of installation
• Set up the light on a solid, level surface
close to a socket.
• Make sure that there is no risk of it tipping
and that the cord does not pose a trip
hazard.
Turning the light on/off
1. Insert the plug in a socket.
2. Arrange the light in the desired position.
3. Set the On/Off switch to I.
4. Set the On/Off switch to O to turn off the
light.

Replacing the bulb

• Bulb service life: 30 000 hours
• The bulb cannot be replaced.