Learn-Function - LEAD dynamic CDC Manuel D'utilisation

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
This remote control is an accessory for the control-
lable LED DYNAMIC COLOR products in the LEAD
DYNAMIC range.
1
Installation
AAA
AAA
AAA
1.1 Insert the three 1.5 V AAA batteries included into
your remote control unit and switch it on.

Learn-Function

1.3.a Press one of the buttons 1-4 to assign the
luminaire to the respective zone and confirm by
swiping the colour wheel. Complete the entire
'learning' process within 15 seconds.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
1 x
On
15 sec.
Subject to errors and amendments
?
Note
Frequency:
Power supply:
Protection class:
1.2 Note the installation steps from the operating
manual for your LED DYNAMIC COLOR product from
LEAD DYNAMIC. Start the 'LEARN' function on your
LED DYNAMIC COLOR product. If it has a 'LEARN'
button, press the button and follow the instructions in
Section 1.3.a. Otherwise switch your product on and
continue with Section 1.3.b.
2 x
1.
short
1.3.b Press one of the buttons 1-4 twice quickly
within a space of 2 seconds and then once for a
longer period to assign the luminaire to this zone.
Complete the entire 'learning' process within 15
seconds.
Information / Technical support: www.lead-energy.com
service@lead-energy.com
www.lead-energy.com
868 MHz
3 x 1,5 V AAA
IP 20
1 x
2.
long
15 sec.