Cleaning; Maintenance; Troubleshooting - voss.pet Spray Trainer AB 3 Mode D'emploi

7. After you have adjusted the collar to the correct size, you can
cut off the excess length (Fig. 7).
9

CLEANING

NOTICE
► Do not use aggressive solvents/cleaning agents, brushes, sharp objects or
similar for cleaning. These can damage the surface.
► Do not immerse the device in water or other liquids. There is a risk of short
circuit.
Before cleaning, remove the USB cable from the device and wipe the outside of the
device with a slightly moistened cloth.
10

MAINTENANCE

The device is low maintenance. Nevertheless, you should carry out regular visual
checks. Check the device for damage before each use. There are no serviceable parts
inside the machine.
NOTICE
Do not use the device if it shows visible damage.
11

TROUBLESHOOTING

NOTICE
► Do not make any improper changes or modifications to the device.
► Never open the housing. Contact the manufacturer for repairs.
If the device malfunctions or other defects are detected, even after following the below
suggestions, contact the manufacturer. The contact details can be found in chapter 15.
Problem
Dog does not react
to the spray
18
Solution
ऀ Make sure that the device is aligned correctly.
ऀ Make sure that the spray is not obstructed by the coat.
ऀ Set a different spray intensity.
ऀ Make sure that the spray opening is free of dirt and
residues.
INSTRUCTION MANUAL VOSS.PET AB 3
24550 - 03.2021 -
Fig. 7
03
v