Control Panel Indicators; Service Indicator - Titan IMPACT 1040T Mode D'emploi

OPERATION
4.7

CONTROL PANEL INDICATORS

The following is a description of the control panel indicators.
Service
Indicator
RAPID
CLEAN

SERVICE INDICATOR

The Service indicator is on when the motor is commanded to
run. This indicator is used by service centers to troubleshoot
motor problems.
PRESSURE INDICATOR
The pressure indicator shows the current operating pressure of
the sprayer. It has three different indications: blinking yellow,
solid yellow, and solid green.
Blinking Yellow
When the pressure indicator is blinking yellow, the sprayer is
operating between 0 and 200 PSI. A blinking yellow pressure
indicator means:
•
The sprayer is plugged in and turned "ON"
•
The sprayer is at priming pressure (little or no pressure)
•
It is safe to move the relief valve between positions
•
It is safe to change or replace the spray tip
If the pressure indicator begins blinking yellow
i
when the pressure control knob is set at a higher
pressure and the relief valve is in the SPRAY
position, either the spray tip is worn or the
sprayer is in need of service/repair.
14
Solid Yellow
When the pressure indicator is solid yellow, the sprayer is
operating between 201 PSI and 1900 PSI. A solid yellow
pressure indicator means:
•
The sprayer is at the proper pressure setting for spraying
stain, lacquer, varnish, and multi-colors
Pressure
Indicator
Solid Green
When the pressure indicator is solid green, the sprayer is
operating between 1901 PSI and 3300 PSI. A solid green
pressure indicator means:
•
The sprayer is at the proper pressure setting for spraying
oil-based and latex house paints
•
The sprayer is operating at peak performance at a high
pressure setting
•
If the pressure indicator goes to solid yellow when the
pressure is set so that it starts at solid green, it indicates
one of the following:
a. Tip Wear Indicator — when spraying with latex or at high
b. Tip Too Large — when a tip that is too large for the sprayer
c. Fluid Section Wear — if a solid yellow pressure indicator
pressure the solid yellow appears. This means the tip is
worn and needs to be replaced.
is put in the gun, the pressure indicator will turn from solid
green to solid yellow.
appears when using a new tip and the pressure is set at
maximum, service may be required (worn packings, worn
piston, stuck valve, etc...).
IMPACT 1040T