Main Area Of Application; Technical Data; Description Of Unit; Airless Process - Titan IMPACT 1040T Mode D'emploi

MAIN AREA OF APPLICATION / DESCRIPTION OF UNIT
2

MAIN AREA OF APPLICATION

This airless sprayer is a precision power tool used
i
for spraying many types of materials including
textured products from a ready-mixed or
powdered formulation.
Read and follow this instruction manual carefully
for proper operating instructions, maintenance,
and safety information.
2.1

TECHNICAL DATA

Gallons per minute (GPM)
Maximum tip size
Maximum pressure
Power
Weight
Maximum hose length
Generator requirement
8
1.15 (4.35 LPM)
1 gun - 0.033"
2 gun - 0.021"
3300 PSI (22.8 MPa)
2.5 HP Brushless DC Motor,
100~120V AC, 50/60Hz, 15A
98 lbs. (44.5 kg)
300' (91.4 m)
5000 Watt, 20A, sine wave
generator, idle-down feature
disabled
3

DESCRIPTION OF UNIT

3.1

AIRLESS PROCESS

The main areas of application are thick layers of highly viscous
coating material for large areas and a high consumption of
material.
A piston pump takes in the coating material by suction and
conveys it to the tip. Pressed through the tip at a pressure of
up to a maximum of 221 bar (22.1 MPa), the coating material
is atomised. This high pressure has the effect of micro fine
atomisation of the coating material.
As no air is used in this process, it is described as an AIRLESS
process.
This method of spraying has the advantages of finest
atomisation, cloudless operation and a smooth, bubble-free
surface. As well as these, the advantages of the speed of work
and convenience must be mentioned.
3.2

FUNCTIONING OF THE UNIT

In the following there is a short description of the technical
construction for better understanding of the function.
Titan Impact 1040T units are electrically driven high-pressure
spraying units.
A gear unit transfers the driving force to a crankshaft. The
crankshaft moves the pistons of the material feed pump up and
down.
The inlet valve is opened automatically by the upwards
movement of the piston. The outlet valve is opened when the
piston moves downward.
The coating material flows under high pressure through the
high-pressure hose to the spray gun. When the coating material
exits from the tip it atomizes.
The pressure control knob controls the volume and the
operating pressure of the coating material.
IMPACT 1040T