Manufacturer's Warranty - Hilti SR 30-A36 Mode D'emploi Original

Trouble or fault
The tool doesn't start.
The saw blade cannot be
removed from the chuck.
9.2 The reciprocating saw is in working order
Trouble or fault
The tool does not develop full
power.
The saw blade cannot be
removed from the chuck.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r5962277.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2186519*
Printed: 19.09.2019 | Doc-Nr: PUB / 5391396 / 000 / 03
Possible cause
The transport lock is engaged.
The locking lever was not pushed
as far as it will go.
Chuck clogged by residues from
sawing operations.
Possible cause
The control switch is not fully
pressed
The battery is discharged
The locking lever was not pushed
as far as it will go.
2186519
Action to be taken
▶ Disengage the transport lock.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
▶ Remove the residues from
sawing operations and regularly
clean the chuck from the
outside. Care of the power tool.
→ page 9
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Push the locking lever as far as
it will go and remove the saw
blade.
English 11