Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1
Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2
Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3
Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.4
Installing the scaffold hook (accessory)
1. Engage the transport lock.
2. Install the scaffold hook.
5.5
Inserting the saw blade
Use only saw blades with a 1/2" connection end.
1. Activate the transport lock or separate the battery from the power tool.
2. Check that the connection end of the accessory tool is clean and lightly greased. Clean it and grease it if
necessary.
3. Push the locking lever up as far as it will go and hold it in this position.
4. Push the saw blade into the chuck from in front.
5. Allow the locking lever to return to its original position.
6. Grip and pull the saw blade to check that it is locked in position.
5.6
Installing the dust removal adapter (USA: accessory)
1. Pull the contact shoe out.
2. Set the dust removal adapter on the contact shoe mount.
3. Insert the lightly greased contact shoe fully into the guide.
8
English
Printed: 19.09.2019 | Doc-Nr: PUB / 5391396 / 000 / 03
2
3
4
2186519
*2186519*
Publicité
Table des Matières
