Alpine EZi-DAB Manuel D'utilisation page 9

Listening to EZi-DAB
Depending on how your unit has been installed, there are three possible methods for hearing EZi-DAB
through your Head Unit:
Auxiliary input Select the AUX IN source on your Head Unit if EZi-DAB has been wired in as an
auxiliary source.
FM direct inject This method effectively takes over your FM source and replaces it with output from
EZi-DAB when you switch EZi-DAB on. Select the FM radio source on your Head
Unit and tune to a particular frequency (default 87.6 MHz). Depending on your
installation this method may also retain access to your normal FM stations to allow
for traffi c announcements and data services used by some navigation systems. You
can change this frequency in Settings, see page 14.
FM broadcast This method broadcasts the output from EZi-DAB over FM to your car antenna. Select
the FM radio source on your Head Unit and tune to a particular frequency (default
87.6 MHz). You can change this frequency in Settings, see page 14.
Selecting your audio source
EZi-DAB gives you a choice of available audio sources depending on your installation.
Choose from Digital radio, USB (USB connection), iPod (USB connection) or Auxiliary input via (3.5mm
connection) as follows:
Press the button and repeat to step through the source options until you see the one you want then
wait for a few seconds to select the source shown on the bottom line of the screen.
or
Press the button and turn the Select knob to browse through the source options then press the Select
knob to select the source shown on the bottom line of the screen.
Digital radio
iPod
Changing source
(current source on top line)
EN
7