Technical Data; Declaration Of Conformity; Troubleshooting - Madeira 10209807 Instructions De Montage

GB ENGLISH
1 2
Switch off the circuit breaker Remove the right bracket
of the installation site. screws 6 on both sides. Loosen
the left bracket screws 1 mm,
but do not remove them.
4 5
At the installation site, fix ade- Install the ceiling bracket with
quate wall anchors (not includ- the screw kit. Make sure the
ed) to the ceiling. ceiling bracket is securely fas-
tened.
WARNING! Wall anchors must fit the ceiling type, the
weight of the fan, and its torque.
7 8
Hang the fan unit 2 into the Rotate the fan unit 2 until the
ceiling bracket. rotation latch engages.
10 11
Connect the three cable clips Install the cover 1 by attaching
of the remote unit with the it to the ceiling bracket and re-
corresponding clips on the fan install the screws removed in
unit 2. Take care, that the fac- step 2 . Tighten all four brack-
ing colors match. et screws 6.
13 14
Connect the cable clip of Install the luminaire cover 4
the fan unit 2 with the clip and check it for secure fitting.
on the luminaire base 3.
Install the luminaire base 3 to
the fan unit 2.
86
3
Unscrew the outer six screws
from the ventilator and keep
them for step 12 .
6
Connect the cable to the termi-
nal as follows:
L Brown
N Blue
Yellow/Green
9
Slide the remote unit into the
ceiling bracket as shown.
12
Install the three blades 5 to the
motor of the fan unit 2 with
two screws per blade. Use the
screws from step 3 .
15
Switch on the circuit breaker
of the installation site.

TECHNICAL DATA

Nominal voltage
Nominal power of motor
Nominal power of lighting
Fan diameter
Lamp
Luminous flux
Color temperature
Speed settings
Timer settings
Protection Class
Degree of protection
Weight
Remote control
Radio frequency
Transmit power
Batteries

DECLARATION OF CONFORMITY

Hereby, HORNBACH Baumarkt AG declares that the radio equipment type "remote control" is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available
at the following internet address: www.hornbach.com/productcompliance/

TROUBLESHOOTING

Fan does not start. Check circuit beaker respectively circuit fuse.
Disconnect from mains supply and check connection terminals inside
the fan.
Light does not work. Disconnect from mains supply and check connection terminals inside
the cover.
Fan runs unevenly
Disconnect from mains supply and check if the blades are correctly
and/or wobbles. installed to the motor.
Disconnect from mains supply and check if the ceiling bracket securely
fastened at the ceiling.
If the problem persists, start exchanging the position of single blades.
Fan sounds noisy. Disconnect from mains supply and check for loose or overtightened
screws.
ENGLISH
220-240 V~ / 50 Hz
28 W
22 W
112 cm
LED, not replaceable
2000 lm
3000K / 4300K / 6500K
Five speed levels / via remote control
2 - 4 - 8 hours / via remote control
/ I
IP20
5.7 kg
433.92 MHz ± 100 KHz
Max. -27 dbm
2 x 1.5 V AAA
GB
87