Disposing Of The Packaging - Vorwerk VC100 Mode D'emploi

Disposal and environmental protection
Remove the batteries from the device
• Remove the rechargeable vacuum from the charging unit.
• Let the vacuum run until it dies.
• Check to see if the batteries are completely empty by trying to turn the device
on. If the motor starts, repeat the entire procedure.
• Open the vacuum.
• Remove the cover.
• Remove the 4 screws.
• Remove the motor block with the batteries.
• Disconnect each individual connection wire and remove the batteries.
Caution! Risk of injury from leaking batteries!
Leaking batteries must not come into contact with the eyes and mucosa.
• Wash your hands and rinse your eyes with clear water. If you have
additional health complaints, consult a doctor.
6.3

Disposing of the packaging

The packaging is an important part of our product: it protects our devices from
damage during transportation and reduces the risk of a device fault. For this
reason, we cannot avoid using packaging. If you need to return or send in your
device during the warranty period, or after, to the service or customer service
department, the original packaging is the best protection against damages in
transit.
If you nevertheless wish to dispose of the packaging, you can do this at any time
and without limitation via your regional facilities (waste paper skip, yellow skip,
recycling depot, waste paper collection, etc.).
21
EN