Sony SU-PF2 Mode D'emploi page 7

Assembling the Floating Stand
For Sony dealers
The following instructions are for service personnel only. Read these instructions
carefully for safe installation and maintenance.
Tip
Lay the packing box of the Floating Stand, etc., on the floor and place the pillars on the box with their rear sides
(the side the cable cover is to be attached to) facing up. Set the box high enough that the bottom plate can stand
upright to stabilize assembly, as illustrated below. Also, if you spread the cushioning sheet on the floor,
damage to the floor can be avoided.
Attach the bottom plate to the pillars and secure them with screws.
1 Place the bottom plate and the pillars so that the protruding part of the pillars and the concave part of the
bottom plate unite.
2 Tighten all the screws to halfway, and then tighten each firmly.
Note
When using an electric screwdriver, set the torque setting to about 1.5N·m.
Do not use an impact driver. If you use an impact driver or an electric screwdriver with the torque
setting out of the specified range, screws may be excessively tightened, which may damage the screws or
product. The stand may fall and serious injury may result.
Bottom plate
Pillars with a glass panel
Use the packing box, etc.,
to align the screw holes.
7
(US)