Operator Duties - Cillit PIONEER Notice De Montage Et D'utilisation

7. Changing the lime scale
protection unit
As soon as the indicator LED "IN OPERATION" goes
out, the lime-scale protection unit must be changed.
I. Isolate the water pipe before and after PIONEER
and release the locking screws at the side of the
device (see Fig. 13).
II. Remove the device cladding.
III. By opening the black drain screw at the bottom
of the transparent cylinder, you can carry out the
pressure discharge (see Fig. 14).
IV. Unscrew the transparent cylinder then manually
(see Fig. 15).
V. Now detach the lime scale protection unit (see
Fig. 16). You can, without any hesitation, put the
lime scale protection unit in the domestic waste
or send it to be recycled.
VI. Open the protective covering of the new lime
scale protection unit and remove it from the
packaging using the hygiene gloves supplied
(see Fig. 17).
VII. Now set the lime scale protection unit on the two
titanium electrodes in such a way that the points
of the electrodes stick into the two conduits of
the lime scale protection unit see Fig. 18).
VIII. Now push the lime scale protection unit until it
clicks over the electrodes (see Fig. 19).
IX. Now tighten the transparent cylinder again
manually.
X. Now confirm that the lime scale protection unit
has been changed, by holding the "RESET" key
for around three seconds (see Fig. 20). The
green indicator light "IN OPERATION" now lights
up again.
XI. Finally check that all cable connections are tight
and fit the device cladding using the two locking
screws.
8. Inspection
To guarantee the best level of hygiene safety,
efficient working and long life for the device, we
would recommend you carry out a regular visual
check of the device (at least once a week) and
check the operating
Professional maintenance / servicing by your
expert fitter or our Cillit customer service also
provide the highest safety levels.
status (LED lights).

9. Operator duties

Although you have purchased a durable and easy
to maintain product, every technical system
requires regular service to guarantee its correct
operation. A precondition for the operation and
any warranty and guarantee claims is the compli-
ance with the specifications listed in these
operating instructions. These specifications
concern in particular:
– normal use of Cillit PIONEER
– the operation within the operation limits
(s. technical data)
– correct fitting by the approved specialist
company
– regular tests being carried out
– service- and maintenance work being carried
out by your specialist fitter or the Cillit
customer service
Protect your rights and have all the service and
maintenance work, and the replacement of spare
and wear parts carried out solely by specialist
personnel (installation company familiar with the
device or Cillit customer service).
Make sure you only use original Cillit spare and
wear parts - these will guarantee you reliability for
many years! We would recommend entering into a
service agreement with your fitter or the Cillit
customer service.
10. Warranty
In the case of a breakdown during the warranty
period, please contact your trade partner giving
the device type (see technical data or name plate
on the device), the installation company or Cillit's
customer service. The national statutory warranty
provisions shall apply as amended.
GB
11