Description Of Controls; Dispensing Coffee; Dispensing Steam; Dispensing Hot Water - Quick QM67 Mode D'emploi

Mod. 0992P
Do not disperse the packaging items in the environment
but dispose of them properly.
8. INSTALLATION
The machine is delivered ready for installation in
accordance with the rating plate data.
Make sure that the electric line has the same
characteristics as the machine.
The power supply system must have a cut-out or
automatic main switch with an efficient earthed outlet. If
there is no electrical safety, have qualified personnel
install a bipolar differential magnetothermic switch as
required by the safety regulations in force.
It is obligatory to earth the appliance.
The manufacturer declines all responsibility
if this accident prevention rule is not
complied with.
Be careful not to damage the power cord by bending,
crushing or putting stress on it.
Do not unplug the machine by pulling on the cord but by
gripping the plug.
We recommend not
niches/cubby-holes or similar to prevent operational,
restocking and maintenance problems.
 Install the machine on a level, dry, sturdy and stable
surface at a height of 80 cm from the floor;
 Position the machine and insert the plug in the power
outlet.

8.1. Description of controls

1. Main switch (Fig. 1, pos. 1)
Use it to turn the machine on to dispense coffee. The
green indicator light comes on (Fig. 1, pos. 3).
2. Water and steam switch (Fig. 1, pos. 2)
Use it to turn the machine on to dispense hot water
and steam. The green indicator light comes on (Fig. 1,
pos. 4).
3. Coffee dispensing handle (Fig. 1, pos. 7)
Move the handle upward to dispense from the coffee
unit. Move the handle downward to stop dispensing.
4. Coffee circuit pressure gauge (Fig. 1, pos. 9)
Indicates the pressure of the coffee boiler and the
pump pressure while coffee is being dispensed
5. Steam pressure gauge (Fig. 1, pos. 10)
Indicates the pressure of the steam boiler.
6. Hot water valve (Fig. 1, pos. 11)
Turn the knob counterclockwise to dispense hot
water from the water nozzle (Fig. 1, pos. 12)
8. Steam valve (Fig.1 pos.13)
Turn the knob counterclockwise to dispense steam
from the steam nozzle (Fig. 1, pos. 14).
9. OPERATION
9.1 Starting
 Fill the water tank (use drinking water, softened if
possible)
placing the machine
 Turn on the main switch (Fig. 1, pos. 1) and wait for
the machine to refill the boiler and reach the operating
temperature.
 Turn on the steam boiler switch (Fig. 1, pos. 2) and
wait until the operating pressure is reached (1.2 bar).
The first time you use the machine, let approx.
0.5 litres of water flow, with the machine hot,
in order to rinse the unit, pressing the coffee
dispensing switch and the hot water dispensing
switch to rinse the exchanger circuit.

9.2 Dispensing coffee

 Unhook the filter holder from its seat, turning it
clockwise
 Put one or two doses of coffee in the filter (depending
on the inserted filter) using the special doser
 Press the coffee with the tamper.
 Rehook and tighten the filter holder in its seat, turning
it counterclockwise.
 Line the cups up with the holes where the coffee
comes out, located under the filter holder.
in
 Raise the coffee dispensing handle (Fig. 1, pos. 7) and
begin dispensing after a few seconds.
handle when the desired amount has been reached.
Be careful of the hot parts of the machine, especially the
dispensing unit and the steam pipe. Never put your
hands under the steam pipe or unit when carrying out the
relative operations.

9.3 Dispensing steam

 Open the valve and discharge a bit of steam
into the drip tray, then immerse the steam nozzle in
the liquid to be heated and open the valve until the
desired temperature has been reached; then close the
valve.
After heating the beverage, discharge a bit of
steam from the pipe to clean the nozzle holes

9.4 Dispensing hot water

 Place the container for collecting water under the hot
water nozzle and open the valve.
9.5 Coffee pressure valve adjustment (Fig. 2, pos. 17)
The machine comes with the valve set to 10 bar. The end
user may adjust the valve to increase or decrease the
pressure.
 Remove the cup warmer.
 Insert the blind filter in the filter holder and hook it
to the unit.
 Activate dispensing from the coffee unit using the
proper handle.
Rev. 01
Lower the
10
10