Campingaz 4 Série Classic LXS Manuel D'utilisation Et Entretien page 11

IFU 4010027163 - Grill Series 3&4.qxp
h) LIGHTING THE BARBECUE BURNERS
- Open the cooking lid.
- Make sure that the control knobs are in the "OFF"
position ( O ).
- Press and turn the adjustment lever counter-clockwise
and put it in a full flow position (
If your barbecue grill is equipped with a
piezoelectric igniter:
- Press immediately on the igniter button ( ) until it clicks.
- If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
If your barbecue grill is equipped with an electronic
spark igniter:
- Press immediately on the switch (
occurs. Continue pressing for a few seconds until the
burner is lit.
- If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
Once the burner is lit, there are two ways of lighting
another burner:
Firstly, repeat the lighting operation described above;
Secondly, light the burner to the right or left of the first
burner lit, then the other burners in turn by turning the
adjustment button to the full flow position (
If the piezoelectric ignition or the electronic ignition
doesn't work, use the manual ignition (following
paragraph).
i) LIGHTING THE BARBECUE MANUALLY
- Open the cooking lid.
- Make sure that the control knobs are in the "OFF"
position ( O ).
- Light a match and
then bring it from
the back of the
barbecue grill
toward the burner
- Push the control
knob in and turn it
anticlockwise until
it is in the full flow
position ( .
)
stainless steel burner
10/10/2013
j) EXTINGUISHING THE BARBECUE
stainless steel burner
Return the control knobs to the "off" position (O), then close
the cylinder valve.
k) LIGHTING THE SIDE STOVE
The stove may operate independently or in conjunction
cast iron burner
with the grill burner. Before igniting the camping stove, be
sure that the lid is open and then flipped away.
Lighting:
- open the gas cylinder valve.
- check that there is no gas leak between the gas cylinder
and the stove.
).
- check the condition of the hose connecting the grill
burner to the stove. If there are signs of cracks, call our
After Sales Service to have it replaced.
- Open the valve of the camping stove (+ direction).
- If your barbecue grill is equipped with a piezoelectric
igniter:
Press on the igniter button located to the right of the
control panel and identified in the pictogram (
it clicks. Press 3 or 4 times if necessary.
). A burst of sparks
- If your barbecue grill is equipped with an electronic
spark igniter:
Press immediately on the switch ( ). A burst of sparks
occurs. Continue pressing for a few seconds until the
burner is lit.
- Should the stove fail to light, present a match to the edge
of the burner.
- Adjust the size of the flame to the dimensions of the
container you are using by opening the valve to various
).
extents. Do not use a container smaller than 12 cm or
larger than 24 cm.
l) TURNING OFF THE SIDE STOVE
Close the stove valve (towards the -) and close the valve
of the gas cylinder if the grill burner is not in use.
M) Lighting of the console
The lighting system of the console is powered by 4 type
AA (LR06) batteries provided with the barbecue grill. The
battery holder box is located on the front left support,
behind the left door. Remove the cover of the battery
holder box by sliding it upwards. Insert the batteries while
respecting the polarities indicated and then replace the
cover.
To turn the lighting on or off, press on the stop-
start button located to the left of the console and
identified by this pictogram.
cast iron burner
11
11:22 Page 11
(depending on the model)
(depending on the model)
(depending on the model)
GB
) until