HSK Heizstab 4 Mode D'emploi page 40

Remote control mode (wireless communication)
If there is a dedicated IR controller inside
the room, which sends signals to the heat-
er, then the first signal correctly received
by the heater, automatically switches the
device into receiving mode. When in this
mode, the device will heat with the heat
output dictated by the external controller
while still controlling temperature not to
exceed approximately 60° C . Remote con-
trol mode is indicated by the diode shining
with constant blue light. Every correctly re-
Malfunction alerts
The device constantly monitors all parame-
ters which might indicate damage or any ad-
verse phenomena, and automatically activates
necessary protective procedures. Those are,
Maintenance
• Always disconnect the device from electric-
ity before you start cleaning the radiator.
• Recurrently check level of the heating
medium inside the radiator.
Before disassembly
1. Disconnect the device from electric cir-
cuit and ensure that the radiator has
cooled down before you start disassem-
bling the radiator.
40
User manual — Heizstab 4
ceived signal from the external controller
is indicated by short flash of the diode. If
there is a break in communication (the heat-
er does not receive a signal from the exter-
nal controller for 30 minutes), the heater
will switch to a signal-awaiting mode. The
blue diode will start pulsating steadily and
the device will automatically turn off with
the antifreeze function still active until the
connection is reached again.
amongst others: protection against opera-
tion in 'dry conditions', monitoring of control-
ling and measuring systems. All malfunction
alerts are indicated by a flashing white diode.
• Clean the item with a dry or damp cloth
with a small amount of detergent without
any solvents, abrasive or caustic agents.
2. Be careful – electric radiator filled with
heating liquid may be very heavy. Ensure
all necessary safety measures.