Maintenance Instructions; Safety Recommendations - Walter WALU COOL Notice De Montage

Systeme d'enroulement motorise pour couvertures a barres
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
WALU COOL runs on a 12 V battery integrated in the
housing, which needs recharging from the mains about
every 10 windings. To recharge WALU COOL, plug the
charger into the mains: 220 V plug (the red light comes on).
Connect the jack plug on the WALU COOL handle (the red
light goes out). Charging begins automatically. The red
light comes on when the battery is fully charged.
The battery charger must only be used to charge the sealed
WALU COOL battery. To increase your battery life, we
recommend that you charge it fully each time and only recharge
it when it is completely discharged.
 Keep the WALU COOL out of the reach of children, protect it from bad weather and avoid contact with
chlorinated products.
 In the winter, store the WALU COOL in a dry place and charge it systematically every 2 months using its
charger.
 The battery charger must be stored and used in a dry place.
 Dismantling the motorised mechanism or its charger could lead to a risk of ignition and/or electrocution and
would invalidate the warranty.
 To clean the WALU COOL, wipe over with a damp cloth.
 The battery charger must be cleaned with a dry cloth. Never clean the charger when it is plugged in. Do not
use the charger if the casing is damaged.
 The battery in the WALU COOL must be kept away from any source of heat (flames & sparks) during its
charging cycle.
Always keep an eye on the pool while opening or closing the pool cover.
The cover must only be wound by a responsible adult.
 The WALU COOL motorised mechanism is guaranteed for 1 year (with the exception of the battery
which does not benefit from any warranty) subject to compliance with the recommendations above.
 For the after sales service, contact your dealer first.
Technical specifications:
Electric motor: 12 V
Battery voltage: 12 V
End-of-charge voltage: 14 V
Charging current: 720 mA
Input voltage: 220 V 50 Hz
For pool with max. dimensions 11 x 5 m
Instructions for use (cont.)

Maintenance instructions

Safety recommendations

Warranty
MAINTENANCE INSTRUCTIONS
SAFETY RECOMMENDATIONS
WARRANTY
9
4/4

Publicité

Table des Matières
loading

Table des Matières