Before You Plug In
Before you plug in or use your amplifier please ensure you know how to correctly operate your unit. Incorrect operation or
installation may lead to undesirable results or unit failure which can be avoided by reading this guide.
Your amplifier or combo has been designed to ensure that it performs time and time again with consistent tone. In order to ensure
your amplifier provides years of service it is important that you protect the amplifier from overheating. In order to do this you
should follow a few simple rules that will help protect your investment.
1.
Do not block Vents or disable Ventilation systems. Your amplifier has been designed with a ventilation system that allows air
to circulate over internal components inside the amplifier. in some cases (depending on the model) your amplifier may also
be fitted with a fan to provide additional cooling. Vent holes and fans are designed to ensure your amplifier can perform to its
maximum capacity for the longest time. Blocking and vent holes or disabling any fans that may be fitted will not only void your
warranty, but will almost certainly reduce the life of your amplifier.
2. Correct Loading: In order to get the most power and performance from your amplifier you should use a 4 Ohm load with
your amplifier. EDEN combos are pre loaded with 4 Ohm speaker solutions so you will get the maximum power right out of
the box. When choosing Speakers for EDEN TerraNova heads you should think about what impedance rig your will use. 2x
8 Ohm cabinets will provide a 4 Ohm rig, but if you are only using a single cabinet your are best to opt for a 4 Ohm single
cabinet.
Remember using a load below 4 Ohms will cause stress on the amplifier, so always make sure your minimum total load never drops
below 4 Ohms.
If you are unsure about any about rig impedances or anything else to do with your amplifier speak to the store where you bought it
from, they will be more than happy to provide you with advice.
6
Quick Start Guide | Terra Nova Amplifiers & Combos