Hkoenig NV700 Manuel D'utilisation page 12

Floor Attachment, Extension tube, Adapter
The floor attachment (4) is used for cleaning floors. It is attached to the device with the aid
of the connecting piece (5), extension tube (3) and adapter (2). You can use the floor
attachment with or without a floor cloth. Without the floorcloth the bristles of the floor
attachment will remove stubborn dirt. The floor cloth is suitable for gentle cleaning.
1. Plug the adapter (2) as far as it will go onto the steam nozzle (19) of the device and
screw it on tight.
2. Screw the connecting piece into the floor attachment.
3. Push the narrow end of the extension tube into the connecting piece. The locking
lug of the extension tube must lock in the matching opening in the connecting piece.
4. In the same way, plug the adapter into the open end of the extension tube or, for a
Floor Cloth
Use the floor cloth to gently wipe down the floor.
Filling the Water Reservoir
Caution
Always pull out the mains plug and allow the device to cool down completely before you
•
open the water reservoir. Otherwise there could be an uncontrolled emission of steam.
Do not overfill the water reservoir. Pour a maximum of 260 ml of water into the device.
•
longer tube, the second extension tube and then the
adapter into this.
To disassemble the extension tube, press the release
buttons on the extension tube and adapter and pull it out
To remove the adapter from the device, turn it in the
opposite direction and pull it off.
1. The floor attachment
Press down the end of the clip in the middle of the floor
attachment to open the clip.
2. Insert one end of the floor cloth and release the clip.
3. Stretch the floor cloth over the bottom of the floor
attachment and secure it in the second clip.
4
has two clips on the top of it.
( )