Magontec CorroScout 500 Notice D'utilisation page 25

insulation of non-enamelled built-in devices (for instance electric
tubular heaters, bundle tube heaters of non-corroding steel, tube-fin
heat exchangers of copper) against tank mass.
Diode: Diode test.
Protective current: direct voltage measurements in the measu-
ring range 20 mA and 200 mA for measuring protective current
output of Mg sacrificial anodes or of CORREX
anodes.
Drive potential: direct voltage measurements for measuring the
actual electric voltage between Mg sacrificial anode and tank
(-->2 V range) or the connected CORREX
tank (-->20 V range).
Temperature in °C.
3.5 Operation position
Always operate the measuring device in such a way that the display
can be easily read and that it is pointing upwards.
3.6 Disposal of old devices
CorroScout
the end of its lifetime in accordance with the requirements of the
Electrical Appliance Law (13.08.2005) applicable in all EU countries.
Dispose of CorroScout
dispose of with house hold waste!
3.7 Insertion and replacement of the battery
For proper operation, CorroScout
block battery. When the battery replacement symbol appears in the
display the battery must be replaced. To replace the battery proceed
as follows:
Disconnect CorroScout
switch it off.
Remove the measuring leads from the device.
Undo the fastening screws under the black rubber caps on the
back (bottom) of the device with a suitable screwdriver (Phillips type).
Carefully remove the lower shell of the housing locked at the top
of the device.
Carefully disconnect the battery from the connection clip.
Replace the used battery with a new one of the same type.
® 500 is an electrical device and must be disposed of at
® 500 as an electrical appliance, do not
®
CorroScout ®
® 500 must be equipped with a
500 from the measuring circuit and
500 Operating Instructions
® impressed current
® titanium anode and
25