Listening To The Radio; Playing Cds/Mp3 - AEG SR 4327 Mode D'emploi

guarantee full compatibility with all USB storage media.
For this reason there may be problems in rare cases
with playing back from USB storage media. This is not a
malfunction of the device.
1. Turn the function selector switch (7) to the CD/MP3/
USB position.
2. Keep the II button (12) pressed down in order to
select USB mode. USB appears in the display.
3. Connect a USB storage medium. After a few seconds
the total number of tracks appears briefl y and then
playback begins. The current song and the letters
MP3 and USB appear in the display.
For operating instructions please see the section "Playing
CDs/MP3s".
NOTE:
If there is no CD in the CD compartment at the same
time, the USB connection is automatically selected.
CAUTION:
Before you remove the USB storage medium turn the
function selector switch (7) to the RADIO position.
Card slot (21)
1. If you would like to play back data on an SD/MMC
card please insert it into the opening provided.
2. Turn the function selector switch (7) to the CD/MP3/
USB position.
3. Keep the II button (12) pressed down to select
CARD mode. CARD appears in the display. After a few
seconds the total number of tracks appears and then
playback begins. The current song and
CARD appear in the display.
For operating instructions please see the section "Playing
CDs/MP3s".
NOTE:
• If a USB storage medium is connected it is not
possible to select the memory card.
• If there is no CD in the CD compartment at the
same time, the card slot is automatically selected.
AUX IN socket
To connect analogue replay devices. Via this socket you
can also hear the sound of other playback devices such
as MP3 players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm
stereo jack plug to the AUX IN socket (24).
2. Turn the function selector switch (7) to CD/MP3/USB
or RADIO. The device switches automatically to AUX
IN operation. The radio or CD sound is switched off .
05-SR 4327 AEG.indd 43 05-SR 4327 AEG.indd 43
3. Through the loudspeakers you can hear the playback
of the sound from the external device; with the
VOLUME control (8) you can change the volume. The
CD buttons do not have any function.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfor-
table level.

Listening to the Radio

1. Turn the function selector switch (7) to the RADIO
position.
2. Use the band selector switch (5) to select the desired
frequency band.
3. Tune in the desired station with the station adjust-
ment knob TUNING (4).
4. The FM.ST control lamp (14) only lights up when you
have selected FM stereo and the station is being re-
ceived in stereo quality. If reception is too weak and
there is noise on the station being received, this lamp
will fl icker. Where reception is bad we recommend
switching to FM.
5. For VHF/FM mode pull out the telescopic antenna (1)
and turn it to improve reception.
6. An aerial is integrated into the device for the recep-
tion of AM stations. The machine can be aligned
to the station by turning it. In this frequency band
MP3 and
programs are transmitted in „mono" only.

Playing CDs/MP3

This is how you play a CD
1. Turn the function selector switch (7) to the „CD/MP3/
USB" position. The time display appears.
2. Open the CD compartment (3) by pulling the lid
upwards by the tab (6).
3. Insert an audio CD with the printed side facing
upwards on to the central cone so that the CD clicks
into place and then close the lid of the CD compart-
ment.
4. After a few seconds the total number of songs/tracks
is shown in the display.
5. The CD will play from the fi rst title. The track cur-
rently being played,
display.
6. In order to remove a CD, please press the STOP key
(10), open the CD compartment and lift the CD out
carefully.
Always keep the CD deck closed.
English
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
or MP3 are shown in the
23.03.2009 14:32:36 Uhr 23.03.2009 14:32:36 Uhr
43