Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
U S E R M A N U A L
TECHNICAL DATA
Parameter description
Parameter value
Product name
Tree round Swing
Model
UNI_SWING_01
Maximum load [kg]
180
Dimensions [mm]
1,050 × 1,430–1,875
Weight [kg]
4
1. GENERAL DESCRIPTION
The user manual is designed to assist in the safe and
trouble-free use of the device. The product is designed and
manufactured in accordance with strict technical guidelines,
using state-of-the-art technologies and components.
Additionally, it is produced in compliance with the most
stringent quality standards.
DO NOT USE THE DEVICE UNLESS YOU HAVE
THOROUGHLY READ AND UNDERSTOOD THIS USER
MANUAL
To increase the product life of the device and to ensure
trouble-free operation, use it in accordance with this user
manual and regularly perform maintenance tasks. The
technical data and specifications in this user manual are
up to date. The manufacturer reserves the right to make
changes associated with quality improvement.
LEGEND
The product satisfies the relevant safety standards.
Read instructions before use.
WARNING! or CAUTION! or REMEMBER! Applicable
to the given situation (general warning sign).
The product must not be used by children between
0 and 3 years of age.
PLEASE NOTE! Drawings in this manual are for
illustration purposes only and in some details may
differ from the actual product.
The original operation manual is written in German. Other
language versions are translations from the German.
2. USAGE SAFETY
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury or even
death.
The terms "device" or "product" are used in the warnings
and instructions to refer to Tree round Swing.
2.1. SAFE USE OF THE PRODUCT
a)
If you are unsure about whether the product is
operating correctly or if you find damage, please
contact the manufacturer's service centre.
b)
Only the manufacturer's service centre may make
repairs to the product. Do not attempt to make
repairs yourself!
c)
Regularly inspect the condition of the safety labels. If
the labels are illegible, they must be replaced.
d)
Keep this manual for later use. If the product is
handed over to third parties, the user manual should
be made available to them.
e)
Do not use the product in a state of fatigue, illness,
under the influence of alcohol, illegal drugs or
6
medications significantly limiting the ability to handle
the product.
f)
Do not wear loose clothing or jewellery. Keep hair,
clothes and gloves away from moving parts.
g)
When not in use, please keep the product out of the
reach of children and people who are not familiar
with it or this manual.
h)
Keep the product in good condition. Check before
every use for general damage or damage of the
moving parts. In the event of damage, have the
product repaired before use.
i)
Repairs and maintenance of the product should only
be carried out by qualified staff, using only original
spare parts. This will ensure safety of use.
j)
Do not overload the swing. Exceeding the maximum
permissible user weight may cause damage to the
product.
k)
PLEASE NOTE! The product does not have a backrest
or a safety belt.
l)
This product is not suitable for children under the age
of 3.
m)
The product must be assembled and checked by an
adult.
n)
Use a correctly assembled product. Incorrect
assembly of the product may cause injury to the user.
o)
Ropes, links, rings and other fasteners should be
checked for possible damage resulting from abrasion,
stretching and wear.
p)
To avoid accidents, all parts of the product must be
complete and undamaged.
q)
Do not install the product above concrete or asphalt
surfaces or any other hard surface.
r)
The area underneath the product should be free from
hazardous elements which may cause serious injury.
s)
Do not use the product while standing.
t)
Do not get off the product while it is in motion.
u)
Do not twist the ropes and do not wrap them around
the crossbars.
v)
Do not climb the rigging or other parts of the product.
w)
Do not allow the presence of third parties in the area
of the product use (play zone), this includes children
and animals.
x)
Children should be supervised when using the
product, in particular small children who may not
keep their balance while using it.
y)
WARNING! This product is intended for private use
only and is not recommended for commercial use.
z)
Check and tighten all bolts, nuts and fasteners before
each use.
aa)
The product is intended to be used by a single user at
a time.
3. USE GUIDELINES
The product is used for swinging the user sitting on it. A
movable toy, for home use.
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
Tubes with protective foam
Seat
Rigging with fastening and adjusting
elements
Assembly wrench
3.2. PREPARING FOR USE / DEVICE USE
Assembling the device
•
The seat must be positioned at least 40 cm above the
ground.
•
PLEASE NOTE: Assemble the product on a flat surface,
at least 2 meters from any structure or obstacle (such
as: fencing, garage, house, hanging branches).
•
PLEASE NOTE: The seat, after the completed
assembly, must be positioned at least 40cm, and not
more than 250cm above the ground.
•
The cross beam is not part of the product set.
1)
Open the flaps on the edges of the seat. Insert the
four curved tubes into the openings in the edge of
the seat to form a circle. The narrower end of the pipe
should fit into the wider end of the following one.
PLEASE NOTE! Do not remove shock absorbing foam
from the pipes.
2a)
Press the narrower end of the pipe into the wider end
of the following pipe. Repeat this operation with all
the tubes.
2b)
Close all four seat flaps.
3)
When the flaps are closed, insert the screws (located
at the ends of the ropes) into the eyes in the flaps,
and then into the holes in the tubes. There is one
screw per connection.
To make the work easier, tighten all the elements
by hand until the assembly is completed, and then
retighten them using the wrench.
4)
In the selected location, fasten the top ends of the
ropes to the support, using hooks and a carabiner
(not included). The support on which the swing will
be suspended should be stable and resistant to load.
Adjust the length of the ropes.
7
EN
5)
Height at which the product is fastened:
•
Make sure that there is suitable distance between the
fastening points of the ropes:
(0.04 H + B)
ƒ A: distance between two rope fasteners
ƒ B: distance between the seat attachment points
ƒ H: distance from the ground to where the product
is attached to the crossbar
For example:
H = 2000 cm, B = 1050 cm
(0.04 × 2000) + 1050
A > 1130 cm
•
Both rope fastening points must be strong and
stable.
6)
Adjusting the length of the rope:
3.3. CLEANING AND MAINTENANCE
a)
Use only non-corrosive cleaners to clean the surface.
b)
After cleaning the device, all parts should be dried
completely before using it again.
c)
The product should be stored in a dry and cool place
protected from moisture and direct sunlight.
d)
Remember to regularly inspect the product for
technical performance or damage.
e)
Use a soft, damp cloth for cleaning.
Publicité
Table des Matières
