Fanelite 52WG-9054 STATIA Mode D'emploi page 24

Press the TIMER button to set the timer (automatic stop once the selected time has been
reached), the corresponding LEDs light on: 1 LED = 1 hour / 2 LED = 2 hours / 3 LED = 4
hours / 4 LED = 8 hours. To deactivate the timer, press until all LEDs light off.
Synchronizing the remote control and the receiver
By default, the remote control and the receiver are already synchronized together.
If the receiver is not connected to the remote control, please follow the steps below :
1/ Turn off the power of your ceiling fan using the circuit breaker or switch.
2/ Wait at least 10 seconds then turn on the power again.
3/ Within 30 seconds of turning on the power, press and hold the POWER
button of the remote control for around 5 seconds.
The receiver beeps when the synchronization is complete. You will then be able to use your
remote control to control your ceiling fan.
Controlling several ceiling fans using a single remote control
When several ceiling fans are installed, they can be controlled by a single remote control.
Repeat the above procedure with all the other ceiling fans that you want to synchronize on
the same remote control.
Reverse mode
By default your ceiling fan rotates counterclockwise (summer mode). This mode allows the
room to be refreshed by sending the cold air down and hot air at the top. The winter mode,
meanwhile, will allow you to heat the room by sending hot air down (the blades turn in the
opposite direction, clockwise).
Fixing the wall bracket of the remote control
Notes
- A beep is emitted when a function is activated.
- If you intend to not use your ceiling fan for a long time, we advise you to remove the battery
from the remote control to preserve it.
To change the direction of rotation of the blades, use the switch
located in the rear compartment of the remote control. When you
change the direction of rotation of the blades, you will need to turn
off and on your ceiling fan for the change to occur.
F = forward = Summer = counterclockwise rotation (bottom view)
R = reverse = Winter = clockwise rotation (bottom view)
Install the bracket supplied with the supplied screws and plugs so that
you can store your remote control.
24