Publicité
P
ower suPPly
The machine is designed to operate by default under 220-240 V AC ; 60/50 Hz ; 3 - 2.8 A.
e
leCtrICal hazard
Never open machine when it is switched on. Disconnect the supply lead before opening. Installation,
starting and maintenance must be carried out only by engineers from the maintenance company
approved by the manufacturer or his representative.
This pictogram is displayed on the machine at the points where there is risk of electrocution.
Engineers from the maintenance company only are authorised to work on these parts of the
machine.
u
se
The machine is designed for indoor use only.
The machine must be close to a mains socket that must be accessible at all times.
Otherwise provide a two-pin isolating switch that is easily and quickly accessible in the
installation:
- 2-pole 230 V; 10 A isolating switch if supplied with 220-240 V AC; or
- 2-pole 115 V; 10 A isolating switch if supplied with 120 V AC.
The power socket must have an earth resistance lower than 3 Ω to ensure satisfactory operation
and personal safety according to the regulation in force.
This machine is designed for connection to a neutral to earth network (class 1).
B
usIness equIPment
Refer to the documents supplied with the machine for operations (maintenance, adjustments...)
relating to business equipment (printer...).
B
attery
There is a risk of explosion if the battery located inside the computer is not replaced properly, or
if it is replaced by an incorrect battery type.
Dispose of used batteries according to your country's regulation, or contact your vendor.
Do not expose the battery to excessive heat (direct sunlight, fire...).
6
MAP - 1015 MINI ALBUM PRINTER - Guide de démarrage
SAFETY AND STANDARDS
(PC)
120 V AC ; 60/50 Hz ; 4.7 A
060 675 972 E
Publicité
Chapitres
