EIBENSTOCK EBM 182 Notice Originale page 26

Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains!
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. Regularly the following works have to be carried out or rather
the component parts have to be inspected.
Clean the drilling unit after having finished drilling. Later on, you have to
grease the spindle thread. The ventilation slots always have to be clean
and open. Pay attention that no water gets inside the core drill during the
cleaning process.
After the first 150 hours of operation you have to replace the gearbox oil.
Gearbox oil changes bring about an essential increase of the tool's
lifetime.
Have switch, cable and plug checked by an electric specialist quarterly.
Environmental Protection
Raw material recycling instead of waste disposal
In order to avoid damages on transportation, the power tool has to be
delivered in sturdy packing. The packing as well as the tool and its
accessories are made of recyclable materials and can be disposed
accordingly.
The tool's plastic components are marked according to their material, which
makes it possible to remove environmental friendly and differentiated
because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household
waste material!
In observance of European Directive 2012/19/EU on waste
electrical and electronic equipment and its implementation
in accordance with national law, electric tools that have
reached the end of their life must be collected separately
and returned to an environmentally compatible recycling
facility.
26